Home
About
Contact

My 3D Printer
  ⇒ Plans & BOM My Fab@Home     ⇒ Plans & BOM

 As seen on:


RSS Feed

Fox Charlotte Morning Show
May 19th, 2013

On Friday I was a guest on the Fox Charlotte Morning show “Rising”


 

Written by

9 Comments:
  1. Eric Dumbainski
    November 28, 2013 at 2:04 am #

    you so handsome

  2. Alexander Martins
    January 13, 2014 at 1:21 pm #

    Hi! I’m starting a large printer project and was wondering if you’d be willing to share the plans from the one you built. That’s beautiful work! Thanks!

    • Jim
      March 23, 2014 at 6:00 pm #

      Hello Alexander,

      Yes, there are available here on my site. Click the Plans&BOM link on the left side of the page

  3. Andrea LaMoreaux, NH LAKES Association
    March 21, 2014 at 11:13 am #

    Jim! We would love for your and your 3D kayak to come to our LakeFest 2014: Raft-a-Palooza event! Please let me know how we can make this happen!

    • Jim
      March 23, 2014 at 6:01 pm #

      Hello Andrea, thank you for the invite, I will think about it

  4. Birgitta from Sweden
    March 22, 2014 at 3:49 pm #

    Fantastic!!!

    • Jim
      March 23, 2014 at 6:01 pm #

      thank you!

  5. Andrea LaMoreaux, NH LAKES Association
    April 4, 2014 at 9:16 am #

    Great, thanks Jim! We would love to see you and your kayak at our LakeFest event in August!

  6. swannjie
    May 2, 2014 at 4:48 am #

    Beautiful kayak, and beautiful 3d printer.
    Could you please tell me how much does such a printer cost? And how much time did it take you to assemble it? Would you recommend this for a school? Or its better for personal use, because there might be more things to tweak? and tinker? The advantage of your 3d printer is that it is much bigger – than Makerbot 2, correct? Thanks in advance for your kind attention

Write a Comment

Your email address will not be published. All Fields Required.

© 2014 GrassRootsEngineering.com