Home About Contact
My 3D Printer ⇒ Plans & BOM 3D Printed Kayak ⇒ Plans & BOM My Fab@Home ⇒ Plans & BOM
Archives June 2020 May 2020 April 2020 March 2020 October 2015 September 2015 May 2015 March 2014 May 2013 March 2013 February 2013 September 2012 April 2012 January 2012 December 2011 October 2011 September 2011 August 2011 July 2011 June 2011 May 2011 April 2011 March 2011 February 2011 January 2011 December 2010
As seen on:
RSS Feed
Here is an example of using Skeinforge multiply, by printing four openers at a time. This prints four openers in parallel, as opposed to series which I will get into in a later post.
First layers
Finished
Your email address will not be published. All Fields Required.1
Comment *
Name
Email
Δ
